Find the exact frequency on which the broadcast is broadcast Radio Record. In your city, you can only turn to local broadcasting grids, since there is no single "wave" for the whole country. In Moscow, the main signal is transmitted at 106.3 MHz, in St. Petersburg at 107.5 MHz, and in the regions the frequency range can vary from 100.1 to 108.0 MHz, depending on the quotas allocated by the regulator. If your receiver does not find the station in standard positions, you need to perform a manual search throughout the available range, since in some populated punkra repeaters operate at non-standard intermediate values.
Users often confuse the concept of wave and frequency, believing that it is enough to know the brand of the radio station to successfully set up. Actually, FM band It is crowded, and multiple repeaters of the same network can operate at different frequencies at the same time in the same location to block the dead zones. So if you don’t hear familiar music on the memory button, it doesn’t mean the transmitter is offline – it’s possible that the reception conditions have changed or the interference protection system has gone off and the signal has shifted.
Technical characteristics of FM broadcasting
The majority of music stations, including Radio Record., carried out in the ultra-short range of VHF-2, which in the international classification is designated as FM. This means frequency modulation, which provides high sound quality and stereo sound, but has a limited range compared to long waves. The signal travels within the line of sight of the antenna, so the terrain and the presence of high-rise buildings directly affect what frequency will be received stably.
For the correct operation of the receiver, it is necessary to take into account the step of the frequency grid, which is standardized in Russia and Europe and is 50 or 100 kilohertz. That is why you will not find a station at 106.35 MHz – all values are always multiples of 0.05 or 0.1. Radio Record. This standard uses dedicated slots that are protected from interference by neighboring channels.
- 📻 The main broadcast range is 87.5 – 108.0 MHz.
- 📡 Modulation type: Frequency (FM) with deviation of ±75 kHz.
- 🔊 Standard for stereo coding: MPX or pilot tone 19 kHz.
- 📶 Transmitter power: ranges from 0.1 kW in small towns to 5 kW in megacities.
It is worth noting that the digitalization of the ether (transition to DAB+) in Russia is not yet complete, so analog FM signal remains the main way to deliver content to car radios and stationary receivers. The quality of reception depends not only on the power of the transmitter, but also on the sensitivity of your tuner.
Frequency geography: Table by city
Since the broadcasting license is issued by Roskomnadzor for each specific settlement, the frequency of the broadcasting is Radio Record. In Yekaterinburg, the frequency will be different from that in Novosibirsk or Kazan. This is done to ensure that powerful signals from neighboring cities do not jam each other. Large metropolitan areas often use a network of synchronized transmitters operating at the same frequency, but in remote areas of the area, repeaters on other waves can be installed.
Below is a table of the main frequencies for the largest cities in Russia. Please note that data may be updated, and in some cases up to three different network transmitters may operate in the same city.
| Town | Frequency (MHz) | Power (kW) | Features of reception |
|---|---|---|---|
| Moscow | 106.3 | 5.0 | Confident reception within the MKAD |
| St. Petersburg | 107.5 | 4.0 | Possible interference in the center |
| ekaterinburg | 107.1 | 2.0 | Stable signal. |
| Novosibirsk | 101.7 | 1.0 | Depends on the area. |
| Kazan | 101.2 | 1.5 | Good cover. |
If your city is not on the list, the most likely frequency is in the range of 100-108 MHz. In small towns, a station can broadcast on frequencies that are occupied by other broadcasters in large cities, for example, 98.4 or 99.6 MHz.
⚠️ Note: Frequency changes may be made by the operator without prior notice. If you have moved to another area of the city, the old preset (remembered frequency) can only catch noise.
Problems of reception and search of signal
Frequent problem when setting up Radio Record. It is not the absence of a signal, but the malfunction of the automatic search (Auto Scan). Modern radios often ignore weak signals if there is a more powerful transmitter with a similar name or a different station nearby. As a result, the memory of the device can be stored frequency, which catches only at one point of the garage, and when leaving for the track breaks into hiss.
To solve this problem, it is recommended to perform a manual search (Manual Tuning). By slowly rotating the setting knob or using a 0.05 MHz step-by-step switch, you can detect an alternate frequency that sounds cleaner in your particular location. Sometimes it helps to temporarily disable the RDS function, which tries to identify the station by digital code, but if the signal is bad, it can block the sound.
- 🔍 Complete a full reset of the tuner settings before searching.
- 📡 Check the integrity of the antenna cable and connector.
- 🏢 Raise the antenna higher or change direction.
- 🚫 Avoid parking under metal structures or power lines.
☑️ Diagnosis of poor reception
Also, it is worth considering the seasonal factor: in summer, especially in hot weather, atmospheric interference can be stronger, and in winter the signal passes better, but can be shielded by snowdrifts or icing of the antenna. If Radio Record It was the winter that disappeared, check if the antenna is covered with an ice crust.
Alternative ways of listening
In conditions where the FM-ether is silenced or the quality of the analog signal is unsatisfactory, the logical solution is to switch to digital platforms. Radio Record. It actively develops online broadcasting, which is available anywhere in the world where there is an Internet. This allows you to listen not only to the main air, but also to thematic channels without excess water and with a higher bitrate.
For vehicles not equipped with support Android Auto or Apple CarPlayFM transmitters can be used. These devices connect to your smartphone via Bluetooth and broadcast the sound to the free FM frequency you choose in the car. So you create your own wave for Radio Record, for example, at 87.9 MHz, where there are no other stations.
⚠️ Note: When using an FM transmitter, choose the frequency as far away as possible from the city's high-power radio stations, otherwise the sound quality will be low due to interference.
List of popular online channels
Main air, Record Dance Core, Record Chill-out, Record Deep, Record Trancemission
In addition, many modern head devices support the installation of applications directly. Check out your multimedia app store – there may already be an official client that provides a steady flow of data via a 4G modem or smartphone.
The influence of relief and development on the wave
Radio waves of the VHF band on which it operates Radio Record.It is very much dependent on physical obstacles. The signal does not circle large objects such as hills or massive buildings, but is reflected off or absorbed. This creates what are called “radio shades,” where reception on the city’s main frequency may not be possible, even if you’re only a couple of miles away from the transmitting tower.
In urban environments, multipath propagation is often observed, when the signal does not come to the antenna directly, but through reflections from the walls of buildings. This causes an "echo" or whistling effect in the sound. In such situations, switching to a less powerful frequency or changing the antenna orientation, if possible, sometimes helps (for example, in portable receivers).
- 🏙️ In the city center, the signal may be worse due to screening high-rise buildings.
- 🌲 In the forest, signal attenuation occurs faster due to the moisture of the foliage.
- 🌉 On bridges and overpasses, reception is usually improved.
- 🏠 Inside reinforced concrete buildings (bunker effect) reception is almost impossible.
Helpful tip: If you live in a low-lying area or are surrounded by dense buildings, consider installing an external active antenna on your roof or balcony to ensure stable FM reception.
FAQ: Frequently Asked Questions
Why did Radio Record go missing when it was caught before?
This may be due to scheduled work on the transmitting tower, changing the frequency of broadcasting in your area or breaking the antenna in the car. Try to search again or check the online broadcast.
What is the radio frequency in Moscow?
The main frequency of broadcasting in Moscow and Moscow region is 106.3 MHz. However, in some areas of the region, repeaters can operate at other frequencies.
Can you listen to Radio Record without the internet?
Yes, it is enough to have a regular FM radio, tuned to the appropriate frequency in your city. The Internet is only required for online broadcasts.
Why is there another station on one frequency?
You may be in a nearby city’s transmitter receiving area that uses the same frequency, or your local operator may have changed the broadcast format. Check the current data for your location.
The frequency of the radio record depends on your location. In Moscow it is 106.3 FM, in St. Petersburg – 107.5 FM, in other cities – look in the range of 100-108 MHz.